MAINTENANCE
With minimal care, your system is designed to serve you for many years. While constant
attention to your system is not necessary, the following suggestions will ensure your system’s
performance and your convenience and satisfaction.
MAINTENANCE
Your system should be serviced every 1-2 years (or as needed) by a factory authorized service
technician to ensure that all components and overall system are functioning properly.
SERVICE ISSUES
If the Triton control valve system display does not appear, check to make sure the system is
plugged in and that there is power at the receptacle. If the unit does not respond with power
present, contact your WaterTech Dealer.
The manual bypass valve (which is located at the rear of the unit) is designed to isolate the unit
from the plumbing for servicing or to shut off the water supply to the unit in the event of a leak
at the conditioner. Consult the operating diagram on page 9 of this manual for instructions to
position your bypass valve for either service or isolation.
If you experience an extended power outage (over an hour in length), you may need to reset the
time of day on the Triton control valve. The internal battery is designed to retain the time of day
for up to 24 hours. There is no need to reset any other part of the program as this is kept in
non-volatile, permanent memory. Consult the programming instructions on page 2 of this manual
for instructions to set the electronic time clock of the Triton control valve.
IF YOU EXPERIENCE A CHANGE IN WATER QUALITY:
1.
Check to see if your system has power.
2.
Check to see if your system is in bypass (see Bypass Illustrations on page 9)
3.
Check to see if the drain line (see Drain Line Connection on page 7) has a kink that may be
restricting flow during backwash. Correct, if necessary, or contact your WaterTech Dealer.
4.
Place system in manual regeneration.
5.
Contact your local WaterTech Dealer
4
