Watersnake ADVANCE SWBL 42, Owner'S Manual

Page: 13 / 32

www.watersnake.com.au
13
SHORT-TERM STORAGE OF YOUR WATERSNAKE MOTOR
If you are going to be gone for a short break or there is rain forecast and the
motor is to remain on the boat, we recommend covering the motor to protect
the electronics. Even better, make sure that you have a safe non-damp area that
your trolling motor can stay in room temperature.
LONG-TERM STORAGE OF YOUR WATERSNAKE MOTOR
If you are not going to use your motor in the off-season, put your motor in a
safe place where no water or extreme cold or hot temperatures can get in. We
suggest making a place under-cover away from moisture, this should protect the
electronics such as the circuit board and speed control unit.
SERVICING YOUR WATERSNAKE ELECTRIC MOTOR
For servicing please contact the distributor in your country. Your local distributor
can be found on the back page of this manual. If in Australia a current list of
authorised service agents can be found at Jarvis Walker’s Anglers Central
Service Centre website –
www.anglerscentral.com.au
Schematics and parts lists are also available from the Anglers Central Service Centre website
TROUBELSHOOTING QUICK REFERENCE GUIDE
A signifi cant number of issues can be caused by a disruption of power supplied
to your Watersnake motor. Careful inspection of your deep cycle battery,
wiring and fuse / circuit breaker set up should be completed before assuming
that there is a fault with your motor.
No power / Reduced power
• Check that battery connection has not been reversed (reversed polarity)
• Check that your deep cycle battery is fully charged
• Check terminals / connections are secure and not loose
• Check terminals / connections / fuse or circuit breaker for any signs of
damage, corrosion or build up of debris
• If battery lead has been extended, ensure correct gauge wire has been used
(refer to table on page 11 of manual)
• Remove propeller and check for any build up of fi shing line / weed or any
other debris
• Check that propeller pin (shear pin) is in place
• Armature or magnet cracked or dislodged – grinding noise will come from
motor (CONTACT REPAIR AGENT)