Installation on
Wall / Overhead-showers
Instructions are the same for wall monuted shower
arms and overhead showers.
CLEO will fit on all standard (1/2" BSP) shower arms.
Step 1
Disconnect your shower-head from the shower arm &
clean the thread with sand paper to remove any debris.
Now wrap the thread of the shower arm with Teflon
tape to prevent leaks.
Step 2
Ensure 2 washers are inserted into the top connector of
the CLEO and wrap the bottom connector thread with
Teflon tape to prevent leaks.
Step 3
Align the CLEO top connector with the thread of the
shower arm & rotate clockwise to tighten.
Step 4
Flushing – Step away from the path of the water, turn on
the water and let the water flow out for 3 minutes. This
will flush out discoloured water – this is just carbon dust,
and it is not harmful.
Step 5
Align the bottom thread connector of your CLEO with
the shower-head connector and rotate clockwise to
tighten fully. You will need to use a washer for the
shower head connector as well.
Use a spanner to tighten. If there are leaks, check/insert
washers and tighten again.
Summary of Contents for Cleo SFU-717
