• Quality of the Water and Filters My Perfect Colon:
◦
Use clean running water or, if you have any doubts about the quality, use My Perfect Colon water
filters. Alternatively, use bottled water;
◦
Use of the filter D is optional. If you want to use it, fit between the C4 tube fitting and the F tube;
◦
By mounting the filter, the quantity of water supplied is slightly reduced and in proportion to the
quality of the water (the more impurities are present in suspension in the water, the more the flow
tends to be reduced - see table 1 as a reference for the quantity of water supplied for each session
under normal conditions);
◦
Warning: Never use the filter for multiple irrigations. Replace the filter after each irrigation to
ensure the purity of the water, an adequate flow, and avoid the proliferation of bacteria between one
irrigation and the next. Replacement filters are available on the website www.myperfectcolon.com e
www.waterpowered.eu.
RECHARGE MANAGEMENT
• The supplied cable has a USB socket. To recharge the device, connect the cable to the charging socket
(C2) of the device and the other end to a common charger with a USB port (not supplied);
6
• Make sure that the flow in the tubes is not blocked or slowed down by obstructions or kinks;
• During irrigation, position the bag at the height of about 1m, thanks to the suction cups supplied. Where
the bag is placed on the ground, position it slightly on a slope so that the water is directed towards the
outlet to avoid sucking in air;
• Emptying: after completing the insertion of water, the intestine will begin to empty. Especially during the
first few uses, it may be necessary to wait a few minutes, even 15-30 minutes, before the colon begins
to empty. Make sure to expel all the water. To facilitate emptying, try bending forward, coughing, and/
or doing an abdominal massage;
• Evacuation times are subjective and may vary from session to session.
• Amount of water:
◦
For every 30” session, about 475ml of water is dispensed (considering the position of the bag at about
1m of height);
◦
If you prefer less water flow, connect the reducer between the connection of the outlet tube (C4) and
the tube F (fig. 2): in this way there will be a reduction of about 30% of the flow rate compared to the
normal one when the reducer is not mounted (fig. 1). If you prefer an even lower flow (approx. -70%),
connect the reducer (E) between the suction tube (B) and the water inlet fitting (C3 - fig. 3). See the
table below for the specification on the different flow rates;
◦
Depending on the height at which the bag is positioned, the amount of water dispensed per minute
may vary (the lower the bag is positioned, the lower the amount of water dispensed).
Table 1 - Amount of Water per Session according to the different Configurations - considering the
device fully charged and the bag positioned at about 1m of height - (toler. +/-20%)
Time / Session
of 30”
Without
reducer and
filter E (fig.1)
With Reducer
(E) on Outlet
tube (fig.2)
With Reducer
(E) on Inlet
tube (fig.3)
With Filter (D)
on the outlet
tube
With Filter (D)
and Reducer
(E) on the
outlet tube
30 ” / 1
Session
475ml approx. 325ml approx. 150ml approx. 375ml
275ml
60 ” / 2
Sessions
950ml approx. 650ml approx. 300ml approx. 750ml
550ml
120 ” / 3
Sessions
1425ml
approx.
975ml approx. 450ml approx. 1125ml
825ml
