ASSEMBLE INSTRUCTIONS
1. Choose a location for shower which will receive sunlight as much as can.
2. Mount the shower base to concrete slab or wood base with four bolts, nuts and gaskets.
Recommend use wrench. (FIGURE 1)
3. Connect shower head to black shower body tube. Don’t recommend use wrench.
NOTE
: Don’t forget gasket when connect shower head.
4. If shower is with footwash, connect footwash to shower body tube with the adjust nut. (FIGURE 2)
5. Attach hose connector to inlet of shower. (FIGURE 1)
6. Attach garden hose to hose connector and water supply.
INITIAL SET UP OF THE SHOWER
1. Turn the shower handle to
FULL ON HOT
position.
NOTE
: Filling tube with valve in hot position ensures no air pockets are trapped in shower.
This procedure is used for initial set up only.
2. T
urn on water supply to garden hose to fi ll the shower. It will take 2 to 3 minutes to fi ll up 18L or 20L shower
,
and 4 to 6 minutes to fi ll up 40L shower
.
3.
When water fl ows from shower head, turn the shower handle off.
T
urning shower handle off makes water begin
heating in tube.
4. Depending on available sunlight and outside temperature, the shower will take one to two hours to fully
heat water.
5. Water temperature in shower can reach 60ºC in strong sunshine.
WARNING
: To avoid scald, pay attention to turn shower handle to
cold water (blue)
direction before using the
shower. Then setting to desired temperature.
WINTERIZATION
1. Turn off and disconnect garden hose.
2.
Twist off the cap on the outlet valve. The water will now flow out of the shower automatically.
3. Clean and dry the shower parts.
4.
For technical reasons, a small amount of water will alwas remain in the shower. For this reason, it is essential that ̀
the shower is stored in a dark, dry location over winter and protected from frost.
WARNING
1. DO NOT USE SALT OR OTHER ANTI-FREEZINE METHODS. THIS WILL VOID THE SHOWER WARRANTY.
2. RECOMMENDED WATER PRESSURE max.
3,
5bars.
3. ALWAYS START YOUR SHOWER FROM COOL TO AVOID INJURY.
UK
OUTDOOR SOLAR SHOWER INSTRUCTIONS
FIGURE 1
FIGURE 2
Gasket
Adjust nut