WaterLogic WL400 Base Cabinet, Manual

Page: 62 / 84

WL400 Manual Page 62 – Revision: 10-23-2019
Green Heater/Compressor Switch must be in the O=OFF position while the hot tank is empty.
Damage could occur within one minute and the overloads (high limit) will require manual
reset if heater is turned on with an empty hot tank.
11. Connect supply water to water in fitting on back of cabinet. Turn on the Water Supply and flush
RO system to drain for 4 hours. Water should be draining from both Water Out Line and Drain
Lines.
12. After 4 hours, turn off Incoming Water. Connect Water Out Line from Base Cabinet to drain
water in fitting on
WL400 Water Treatment System.
13. Open Bladder Tank and turn on supply water.
14. Allow bladder tank to fill for 1 hour.
15. Fill Hot Tank (Approximately 1 minute). Depress both Hot and Extra Hot Buttons to dispense.
Red light should illuminate above dispensing area after 2 second delay.
16. Fill Cold Tank (Approximately 2 minutes). Blue light should illuminate
above dispensing area.
17. Turn on Green Heater/Compressor Switch. I=ON .