![background image](http://html1.mh-extra.com/html/waterlogic/wl3-fx/wl3-fx_manual_3654483011.webp)
WL3 FX
Manual
Page 11 - Revision: 7-27-2022
OPERATING INSTRUCTIONS
The above picture shows front user interface (UI) and control panel for the
WL3 FX Water
Treatment System.
For Cold Water:
Press
and Hold the “Cold Dispense” Icon
.
For Hot Water:
Press twice (within 3 seconds)
and Hold the “
Hot
Dispense” Icon
. LED will
blink fast to indicate Hot Dispense is activated.
For Extra Hot Water:
Press and Hold the “Hot Dispense” Icon for 10
-seconds to activate the
heater. LED will flash slowly until water is Extra Hot. When the LED stops
flashing, repeat the dispense operation for Hot Water.
For Ambient Water: Press
and Hold the “Ambient Dispense” Icon.
NOTE:
If the user initiates extra hot, but then loses patience and does not want to wait any
longer, then they can Press twice and Hold the “Hot Dispense” Icon to
dispense hot water. This
action will dispense hot water from the hot tank and will NOT cancel the Extra Hot request that
was in process.