WaterLogic WL100 Troubleshooting Download

Page: 2 / 3

WL100

Manual Page 48 Revision: 1‐14‐2019

Red Power Switch is lit but the Red LED on the Front is not lit

Possible Reason

Solution

Bad Transformer

Replace Transformer

Black Power Connector to the
PCB is not properly connected

Properly connect.

Bad Front PCB

Replace Front PCB

Part Number EN‐6130 – WLCP PN 20‐0040

Bad Energy Saver PCB

Replace Energy Saver PCB

Part Number EN‐6131 – WLCP PN 20‐0075

Defective Red Heater /
Compressor Switch

Replace Red Heater / Compressor Switch

Compressor Runs But Does Not Chill

Possible Reason

Solution

Condenser is dirty

Clean the condensing coil of any obstructions or dust.

Reduction of airflow into unit.

Make sure unit is not under minimum ventilation requirements (2
to 4 inches).

Compressor is running very
hot.

Low or lost refrigerant. Refrigerant recharge required.

Summary of Contents for WL100

Page 1: ...ing 1 Red Heater and Compressor Power Switch won t light and the Red LED on the Front won t light Possible Reason Solution Circuit Breaker Check the Circuit Breaker Fuse is Blown Replace Fuse Defectiv...

Page 2: ...CP PN 20 0040 Bad Energy Saver PCB Replace Energy Saver PCB Part Number EN 6131 WLCP PN 20 0075 Defective Red Heater Compressor Switch Replace Red Heater Compressor Switch 3 Compressor Runs But Does N...

Page 3: ...ater and Compressor Switch on I ON Compressor Starting Circuit Turn Red Heater and Compressor Switch off O OFF Remove the Compressor cap on side of the Compressor Disconnect the black and red terminal...