WL100
Manual Page 43 Revision: 1‐14‐2019
WL100
TOWER DRAINING INSTRUCTIONS
Draining Notes
Drain the
WL100 Water Treatment System
for transportation.
WARNING!
STORE UNIT EMPTY. ALWAYS SANITIZE BEFORE REUSE.
The unit must be completely drained and sealed before storing to avoid stagnation and reduce
microbial growth).
Prior to draining the Hot Tank, turn off the Red Heater and Compressor Switch (
O = OFF
) and
dispense 2 liters (½ Gallon) of hot water from the
WL100 Water Treatment System
. As hot water
is dispensed from the faucet of the unit, colder water will be introduced into the
Hot Tank. Since the Red Heater and Compressor switch is turned off, the Heater
will not energize and heat the incoming tap water. Following this precaution
prevents exposing personnel and equipment (drains, catch basin, etc.) to scalding
hot water.
Red Compressor/Heater Switch must be in the O=OFF position.
Disable Cold and Hot Tanks
1.
Ensure the Red Heater and Compressor Switch is off
(O = OFF)
to disable the Heater
and Compressor.
2.
Dispense 2 liters (½ Gallon) of water through the Hot Tank to cool the water
temperature in the Hot Tank and avoid burns.
3.
WARNING!
HOT WATER. Unit produces Hot Water up to 87
o
C (189
o
F).
Water above 52°C
(125°F) can cause severe burns or scalding. Hot water should be dispensed carefully into insulated
container to avoid injury.
4.
Dispense cold still water to relieve any pressure built up in the system.
Drain the Cold Water Tank and Circuit
5.
Remove the Lower Front Panel to
access tank feed lines.
