PLUMBING CONNECTION:
(See Fig. 3 below for a typical water line connection.)
Note: This brewer is designed to operate with water pressure of 30 to 80 psi. If the water pressure exceeds 80 psi, it is
recommended that a water pressure regulator (not included) to be installed and reduce the water pressure to 50 psi.
2.
The Alwaysfreshh2o AP-DWS-HFC1000 water filtering system (included) is required to ensure optimal performance of your
Built-In Appliance. Failure to install this water filtration system will void warranty. It is also recommended that a shut off valve
(included) be installed on the incoming water line to allow the water supply to be turned off for cleaning and servicing.
3.
After installing the desired components onto the incoming water line, flush the water line to remove any impurities that may be
present in the line, flush the water filter also. (Follow the water filters recommendations for the correct procedures).
4.
Installation of the AP-DWS-HFC1000 high flow water filter included with this machine is required.
See AP-DWS-HFC-1000 INSTRUCTIONS
Fig. 3. Fitting and water line connection
Page 7
Fig. 3A. Plastic Tube and Fitting connection.
Fig. 3B.
5.
Connect the supplied polyethylene tube, from filter (cut to length required). Fig. 3A insert into the plastic water inlet elbow
fitting (Fig. 1, item 19) located on the rear of the appliance following the instructions below:
a.
Hand tighten the plastic nut onto the plastic water inlet fitting. (Fig. 3A and Fig. 1, Item #19)
b.
Insert polyethylene tube (Fig. 3A and Fig. 1, Item #26) firmly into the plastic water inlet elbow fitting (Fig. 1, Item #19),
until the tube is no longer able to move further into the fitting.
c.
Loosen the plastic nut. Check to make sure the polyethylene tube, and washers are attached correctly. Inspect
assembled items on the polyethylene tube (Fig. 3A). End of tube should extend out 3/8 inches from the plastic nut.
d.
Reconnect the plastic nut with assembled items and tighten firmly. Use the appropriate connector for other end of 1/4"
plastic tube (To be supplied by installer) to incoming water supply. Turn on water supply and inspect for leaks.
Note: To prevent leakage at the water inlet elbow fitting, use the supplied polyethylene tubing (1/4” OD Polyethylene). Additional
tubing is available from your local dealer.
Summary of Contents for AlwaysFresh H2O AP-UCBS-KIT
Page 19: ...Page 19 NOTES...
