Page 11
SETTING AUTOMATIC BREW TIME:
(Note: The clock must be set in order to have “Brew Start Time” functioning.)
Note: Once set, “Brew Start Time” is stored in the brewer’s internal memory and will be the default “Brew Start Time”
unless changed or the unit is reset.
1.
Press and Hold the “PROGRAM” button for approximately 3 seconds to enter Program Mode. The colon (:) on the display will
begin to flash and a beep is emitted by the brewer to confirm that it is has entered Program Mode.
2.
Press the “PROGRAM” button one (1) time. The display window will show “0:00” or the default brew time and the set light will
flash in the upper right corner of the display window. (Note: you have 30 seconds to begin entering the brew time.)
3.
To set hours, press and hold the (+) button; hours on the display will advance from 00 to 12pm. PM time is set when the green
dot is lit next to the “PM” in the upper left corner of the display box.
4.
To set minutes, press and hold the minus (-) button; minutes will advance from 00 to 59.
5.
To set the volume option, (amount of coffee to be brewed at a selected time), press the button that corresponds to the amount
desired (full pot, half pot, quarter pot options). The light will light when the button is selected.
6.
After setting the brew time, press the program button three (3) times to exit from the menu. The display will show the current
time, the set light will be illuminated in the upper right corner of the display window and the light corresponding to the volume
selection button will be flashing.
TO CANCEL THE PROGRAMMED BREW TIME
1.
Press and Hold the “PROGRAM” button for approximately 3 seconds to enter Program Mode. The colon (:) on the display will
begin to flash and a beep is emitted by the brewer to confirm that it is has entered Program Mode.
2.
Press the “PROGRAM” button one (1) time. Display will show the actual programmed brewing time
3.
To cancel the Programmed Brew Time, press the flashing “VOLUME SELECTION BUTTON”, the light will turn off. Press the
“PROGRAM” button three (3) times to exit the Program Mode. The display will show the current time and both the set light and
“VOLUME SELECTION BUTTON” will no longer be illuminated.
TO RE-PROGRAM A DIFFERENT “VOLUME SELECTION” BREW BUTTON OPTION
1.
Press and hold the “PROGRAM” button for approximately 3 seconds until the display changes and the colon (:) flashes. A
beep is emitted by the brewer to confirm that it is in Program Mode. Press the “PROGRAM” button one (1) time. Display will
show the actual programmed brewing time.
2.
Press a different “VOLUME SELECTION BUTTON” to change the current volume option. The previous assigned “VOLUME
SELECTION BUTTON” light will turn off. Press the “PROGRAM” button three (3) times to exit the Program Mode. The display
will show the current time and the new “VOLUME SELECTION BUTTON” light will be illuminated.
Note: Brewing while the “Brew Start Time” is set will cancel the current “Brew Start Time”, repeat steps 1 - 6 above, in
“SETTING AUTOMATIC BREW TIME:
WARNING: Always make sure an empty container such as a glass decanter, stainless steel carafe or thermos is placed
directly beneath the coffee appliance brew cone when a “Brew Start Time” is set.
If this appliance should fail to function properly, unplug it and contact Waterline at 1-800-522-3949
Summary of Contents for AlwaysFresh H2O AP-UCBS-KIT
Page 19: ...Page 19 NOTES...
