7
11. The sink faucet may now be assembled to the sink or countertop using the assembly
procedure shown in Figure 2. Your faucet may have the poly tube factory pre-attached. If
so, do not connect the tube to anything at this time. If the tube is not pre-attached, do not
attach the poly tube to faucet at this time.
Figure 3.
Standard 1/4” assembly
Optional 3/8” assembly
Step 7. Mounting the filter system
1. While holding the system in its mounting position, mark the holes for the wall screws. Using
a 1/8” bit, drill the pilot holes for the screws. Screw in the mounting screws leaving ¼”
protruding. Hang the mounting bracket on the screws and tighten.
2. If the unit is to be mounted on wallboard, use plastic screw anchors, available at any builder’s
supply and follow the manufacturer’s directions.
3.
DO NOT INSTALL FILTER CARTRIDGES AT THIS TIME.
Spin the filter housing sumps
on to the filter unit and hand-tighten. Use the wrench provided to turn an additional ¼ turn.
