Installation
Attach the Angle Pivot Plates to each side of the Step Assembly using the
hardware provided in the holes it was shipped in; top four (4) holes in the
Runners. Make sure the warning labels are facing outward. The screw
heads should be on the outside and the washers and nylon locking nuts
should be on the inside of the assembly. Tighten securely. Attach the Pivot
Mounts to the Angle Pivot Plates using the Clevis Pivot Pins and Hair Pin
Cotters.
Determine the desired mounting location. Slide the assembly so that the
90 degree corner of the Angle Pivot Plates is against the platform edge.
Mark the location of the four (4) mounting holes in the Pivot Mounts on the
mounting surface. Mounting options include 5/16" through bolts, tapped
inserts or threaded anchor studs. Secure using stainless steel hardware
(not provided) to prevent corrosion. Ensure the step assembly is not
twisted and is at approximately a 45 degree angle (steps level). Test the
assembly for stability before allowing your dog to use. It is recommended
that someone be in the water adjacent to the assembly during the first few
times the dog uses them. Never let your dog swim unsupervised.
The Pivot Mounts are shown installed on the inside of the Angle Pivot
Plates. If preferred, they can be moved to the outside.