Table of
Waterco Multicyclone 70Xl
SAFETY INFORMATION ------------------------------------------- 00
INTRODUCTION -------------------------------------------------- 01
INSTALLATION ---------------------------------------------------- 02
PLUMBING CONNECTION --------------------------------------- 02
FILTER MAINTENANCE ------------------------------------------- 03
FLUSHING OUT THE SEDIMENT CHAMBER ------------------- 03
WARRANTY -------------------------------------------------------- 03
TECHNICAL SPECIFICATION ------------------------------------- 04
DIMENSIONS ------------------------------------------------------ 04
EXPLODED DIAGRAM -------------------------------------------- 05
I pg 01
SAFETY INFORMATION
1. MultiCyclone 70XL is designed to work with water at temperatures greater than 32ºF and less
than 113ºF. The filter should never be operated outside of these temperatures or damage may
occur.
2. The installation should be carried out in accordance to the safety and the specific instructions for
each facility.
3. Any modification of the filter requires the prior consent from Waterco. Original replacement
parts and accessories authorized by the manufacturer ensure a high level of safety. Waterco
assumes no liability for the damage and injuries caused by unauthorised replacement parts and
accessories.
4. The user should make sure that the installation is carried out by qualified authorised persons and
that these persons have first carefully read the following instructions.
5. The operating safety of the filter is only guaranteed if the installation and operation instructions
are correctly followed.
6. In the event of defective operation or fault, contact Waterco or its nearest authorised service
agent.
7. To reduce the risk of injury, do not permit children to use this product unless they are closely
supervised at all times.
8. Incorrectly installed equipment may fail, causing severe injury or property damage.
INTRODUCTION
MultiCyclone 70XL is capable of saving water and reducing filter maintenance.
The MultiCyclone 70XL works on the basis of centrifugal water filtration. There are no moving parts
to wear and tear, and no filter media to clean or replace.
EXIT PIPE
CYCLONE RH
CYCLONE LH
TOP SHELL
WATER OUTLET 4” PORT
MAINFOLD PLATE
CYCLONE HOLDER
BOTTOM SHELL
WATER INLET 4” PORT
CLEAR PIPE
STAND
DRAIN / FLUSH VALVE
Incoming water is guided by a diverter plate so that it enters multiple hydro cyclones tangentially
generating a strong centrifugal effect. This spins the sediment out to the hydro cyclone’s wall and
then spirals it down to the sediment chamber, while the cleansed water spirals upwards.
