Waterco Chemflo Plus, User Manual

Page: 7 / 20

Page 5
Installation Guide
Choosing a good location
The is manufactured from weather resistant materials and is designed for
operation in full sun and rain. However, your will benefit if it is protected from
the weather. The Power Supply should not be mounted close to where
chemicals are stored (eg acid and chlorine) as vapours from these chemicals are corrosive
and may damage the electronic controls within the unit.
Insect intrusion (particularly ants) can cause problems with all equipment. Ensure that the
pool equipment area is kept free of insects as much as possible. Insect intrusion is not
covered under the warranty.
Installing the Controller
Locate the Power Supply close to the filtration pump so that it may be
connected easily. Connect the Power Supply to the mains power outlet of the
pool area and make sure this outlet meets all applicable Australian Standard at the time of
installation.
Mount the Power Supply at least 1.5m above the ground and at least 3m from
the pool water. A mounting template has been provided with the that shows
you where to place screws on either a wall or post.
The PUMP socket outlet in the base of the Power Supply is dedicated to the
filtration pump only. Do not use a double adaptor to connect another pump as this will
overload the system and void warranty.
Your has two other power outlets on its base, which can be used to run
lighting or an SWC unit (or other pool equipment). These outlets are also timed, so
accessories can be set to come on and turn off automatically.
Installing the Injection Manifold
The injection manifold should be installed on the return (pressure) side of the pump, after
accessories such as heater, but before the chlorinator cell if fitted. It can be plumbed in as
an elbow or an in-line fitting. Ensure that the water flow is in the correct direction (as
marked on the injection manifold).
Make sure the Y-piece is installed close to the
manifold.
Installing the Probe into the Injection Manifold
The probe has a bayonet fitting. To install the probe, simply insert it into the injection
manifold and twist to lock the bayonet fitting. Ensure that the o-ring seal is not twisted or
out of place.