Airswitch Models (Whisperair S and Whisperair S Elite)
The Whisperair S and Whisperair S Elite come with an Airswitch Controller and connecting tubing
to provide remote activation / deactivation of the Blower. The Button for the Airswitch Controller
is designed to be installed in the shell of the Spa and is connected to the Blower via the tubing.
A Waterco supplied Airswitch Button and connecting tubing must be used with these models of
Blower to ensure trouble free operation.
For easy installation / removal of the remote button for the Airswitch, make sure there is sufficient
free length of tubing to pull through the shell of the Spa and connect to the button. Once installed,
the join between the Button Flange and the Spa shell should be sealed with a silicone sealant.
NOTE: The air tubing should never be exposed to direct sunlight and should preferably be buried
alongside the pool piping where possible. Avoid crushing or kinking the hose.
To remove the remote button, from the shell of the spa, simply slide a sharp thin knife under the
Button Flange to cut the silicone bead and then lift out.
OPERATION
Operation will greatly depend on the electrical connection between the Blower and the other spa
equipment. If you are using a single controller to operate all your spa equipment, refer to the
operating instructions of the controller.
Airflo and Whisperair
Simply plug the power cable into a power point and switch it on.
Airswitch Models (Whisperair S and Whisperair S Elite)
To operate those Blowers with an Airswitch, simply press the remote button to switch the Blower
on / off.
