GENERAL INSTALLATION & SERVICE WARNINGS
The control valve, fittings and/or bypass are designed to accommodate minor plumbing misalignments . There is a small
amount of “give” to properly connect the piping, but the water softener is not designed to support the weight of the plumbing .
Do not use Vaseline, oils, other hydrocarbon lubricants or spray silicone anywhere . A silicone lubricant may be used on black
“O” Rings, but is not necessary .
Avoid any type of lubricants, including silicone, on red or clear lip seals.
Do not use pipe dope or other sealants on threads.
Teflon
®
tape must be used on the threads of the 1” NPT inlet and outlet, the
brine line connection at the control valve, and on the threads for the drain line connection . Teflon
®
tape is not used on the nut
connections or caps because “O” Ring seals are used . The nuts and caps are designed to be unscrewed or tightened by hand
or with the special plastic Service Wrench, #CV3193-02 . If necessary pliers can be used to unscrew the nut or cap . Do not
use a pipe wrench to tighten nuts or caps .
Do not place screwdriver in slots on caps and/or tap with a hammer.
SITE REQUIREMENTS
• water pressure – 25-100 psi
• current draw is 0 .5 amperes
• water temperature – 33-100°F (0 .5-37 .7°C)
• the plug-in transformer is for dry locations only
• electrical – 115/120V, 60Hz uninterrupted outlet
• the tank should be on a firm level surface
1 . The distance between the drain and the water conditioner should be as short as possible .
2 . Since salt must be periodically added to the brine tank, it should be located where it is easily accessible .
3 . Do not install any water conditioner with less than 10 feet of piping between its outlet and the inlet of a water heater .
4 . Do not locate unit where it or its connections (including the drain and overflow lines) will ever be subjected to room
temperatures under 33°F .
5 . Do not subject the tank to any vacuum, as this may cause an “implosion” and could result in leaking . If there is a possibility
a vacuum could occur, please make provision for a vacuum breaker in the installation .
6 .
INLET/OUTLET PLUMBING:
Be sure to install Bypass Valve onto main control
valve before beginning plumbing .
(See installation picture to right.
Be sure bypass is connected to treated water inlet
and outlet.)
Make provisions to bypass outside hydrant and
cold hard water lines at this time . Install an inlet shutoff valve
and plumb to the unit’s bypass valve inlet located at the right
rear as you face the unit . There are a variety of installation
fittings available . They are listed under Installation Fitting
Assemblies, page 28-30 . When assembling the installation
fitting package (inlet and outlet), connect the fitting to the
WELL WATER INSTALLATION
MUNICIPAL INSTALLATION
INSTALLATION:
5
