WaterBoss Softener Owner’s Manual
1/14/2011
17
Advanced Customer Settings
Most customers will want to use the factory default settings, so no changes are necessary. However, you can
reset the controller settings if the factory default settings are not suitable for your needs.
Note:
Be sure to check that the Time of Day is correct.
Set High Capacity or High Efficiency
Your appliance can be programmed for High Capacity (HC) or High Efficiency (HE).
High Capacity means the appliance will regenerate less often, but use more salt.
High Efficiency will make the appliance regenerate more often and use less salt. This is the default. The
High Efficiency setting meets or exceeds the requirement some states have for salt efficiency.
To Enter Advanced Customer Settings Mode
A.
Press and hold the Set and Change buttons at the same time for 3 seconds. The display should show
only the controller type. After 3 seconds, the entire screen is lit for a half second, and then “HC”
displays.
B.
Press Change to toggle the digit display between “HC” and “HE.”
C.
When the desired value is displayed, press Set.
Note:
HE ensures the appliance chooses salt settings that get 4,000 grains per pound (570 grams/kg)
of salt for each regeneration or better. This choice meets or exceeds the requirement some states
currently have in regards to salt efficiency.
Note:
All models are equipped with patented capacity guard.
Once in HC or HE, you can set the mode, hours to next regeneration, gallons or liters, time format, time of day,
and time of regeneration.
Step 1
Set Mode
Display reads “Demand Mode.”
To Change Mode
A.
Press Change.
−
Delay Mode allows regeneration at a specific time (for example, at 2 a.m. when less
water is typically being used).
−
Demand Mode triggers a regeneration as soon as softening capacity is exhausted. This
is the default.
B.
When the desired mode is displayed, press Set.
Step 2
Set 96 Hours Until Regeneration
Display reads “96 Hours.”
To Change Setting
A.
Press Change to turn Off. If “96 Hours” is selected, the appliance will work no more than 4
days without a regeneration. Default is for “96 Hours” to be On.
Note:
If there is iron in your water, select this option. If you are using model 950, on most
municipal water supplies, turn this option Off.
B.
When the desired setting is displayed, press Set.
Summary of Contents for 700
Page 34: ...WaterBoss Softener Owner s Manual 1 14 2011 34 Certificates...
Page 35: ...Notes...
