Installation and Service Manual – Under-the-Counter Point of Use 6 Stage Reverse Osmosis System with Pump & UV
Copyright © 2020 WaterAnywhere.
All Rights Reserved.
Page 8
Step 2 - Faucet Installation
For this step, you will need:
Faucet assembly kit included with System
Tubing, cut to the appropriate length
Wrench
Install the faucet onto the
countertop/sink:
Find and identify all of the parts in the faucet bag, as
shown in the diagram.
Add the metal washer (2), and then the rubber seal
(3) onto the threaded nozzle of the faucet (1).
Place the faucet nozzle through the previously drilled
hole in the countertop or sink top, and let it rest on the
sink top.
From the underside of the sink, slide the washers
onto the threaded stem as shown in the diagram.
- (4) & (5) - made of rubber
- (6) - made of metal
Secure the assembly by threading on the locking nut
(7).
Check the orientation and alignment of the faucet and
washers, adjust as necessary, then use a wrench to
tighten the locking nut securely
Notice:
Do not overtighten fittings.
Install the Tubing
Slide the metal nut (10) over the end of the tubing
with the threads facing up.
Add the plastic clamp (9).
Press the plastic insert (8) into the end of the tubing.
Slide the tubing (until it
stops) inside the faucet
nozzle and screw it in by
hand with the nut that was
placed on the tubing earlier
(10).
Connect the other end of
the tubing to the elbow in
the “out” end of the UV
System.
