7
You can program the CX-1 to run continuously or in intervals over a week long period.
a. Select Cleaning Cycle
1-Day Cleaning Cycle
• 1-Day: The CX-1 will run continuously for up to 2
hours and then go into sleep mode. If 2 hours is not
enough, you can wake the robot from the sleep mode
to start another 2-hour cycle. The robot can run for
two “1-Day” cycles on a single charge. This mode is
most effective for thorough cleaning of a dirty pool.
Weekly Cleaning Cycle
•
In “1-Day” Sleep mode the ON/OFF LED is off and
both battery LEDs stay on. The robot will not wake
from this “Sleep” mode until you turn the robot OFF
and ON (or press the “Cleaning Cycle” button). It is
recommended to turn the robot OFF if you do not
intend on using it again immediately.
Sleeping during 1-Day
Cleaning Cycle
Sleeping during Weekly
Cleaning Cycle
• When in Weekly Sleep mode, both Cleaning Mode and
Cleaning Cycle LEDs will turn off. Only the ON/OFF
LED and the battery LEDs will stay on for the entire
time that the robot is in sleep mode. You can leave the
CX-1 in your pool while it’s in sleep mode. If you take
your CX-1 out of the pool, make sure you place it facing
the pool so it can drive itself back in when it wakes up.
• Weekly: The CX-1 will run on a schedule (illustrated
on next page) that will end after 7 days, at which point
the battery will be fully discharged. This mode is most
effective for maintaining a clean pool as it will clean
the debris that slowly accumulates throughout the
week.
Summary of Contents for 77000RR
Page 1: ......
