Water Specialist EE, Manual

Page: 6 / 24

Page 6 EE Man u al
User 3
Flow Rate.
Displays present
fl ow rate.
Not viewed (along with SOFTENING or FILTERING Icon) if ALT A or ALT b is set
in CONFIGURATION 4 and the valve is currently in Standby. When 1.0 is set in
CONFIGURATION 1, the display will indicate the tank currently in Service (“A” or “b”) in
the leftmost digit.
User 1
Typical user display. Shows volume remaining to regeneration. This screen will not be
viewed if the control is set for time-clock operation.
User 2
Displays number of days to next regeneration.
User 4
Displays total volume in gallons since last reset. If a meter is not used this display will be
shown but 0 will be displayed.
PRESS
▼
FOR 3 SECONDS TO RESET TO 0.
User 5
Shows current time.
Setting Time of Day
Push NEXT until time of day screen is displayed. Press and hold
▼
until SET TIME is
displayed and the hour fl ashes once. Press
▲
or
▼
until the correct hour is displayed.
Then press NEXT. The minutes will fl ash. Press
▲
or
▼
until the correct minute is displayed.
Press NEXT to return to the User Displays. Time of day should only need to be set after
power outages lasting more than 8 hours, if the battery has been depleted and a power outage
occurs, or when daylight saving time begins or ends. If a power outage lasting more than 8
hours occurs, the time of day will
fl ash on and off which indicates the time of day should be
reset. If a power outage lasts less than 8 hours and the time of day fl ashes on and off, the time
of day should be reset and the battery replaced.
User Displays
General Operation
When the system is operating, one of fi ve displays may be shown. Pressing NEXT will
alternate between the displays shown below.