Water Hero K-100, Installation & Operation Manual

Page: 23 / 26

22
Network Reset
1. Press and release Button 1; all LEDs illuminate
2. While all LEDs are illuminated, press and hold Button 3 until
the red LED turns off
3. After approximately 15 seconds, yellow LED will illuminate
and the green LED will blink; Water Hero will be in Access
Point mode*
4. Follow directions on P. 8 to connect Water Hero to network
Perform a network reset to connect the device to a new
wireless network or modify e-mail address*
Main Controller
[Side View]
Buttons
Sensor Cable &
Other Connections
LEDs
*Due to battery back-up unplugging the device will not reset the device
1 2 3