Water Control WHRO-700, Installation Manual

Page: 4 / 20

4
NOTE: Use included TDS tester to test water quality quarterly (every 3 months). Verify a
minimum 80% TDS reduction between inlet (raw) water and outlet (product) water.
IMPORTANT: Do not use where the water is microbiologically unsafe or of unknown quality
without adequate disinfection before or after the system.
PRE-PLUMBED COMPONENTS
•
Electrically actuated shut-off valve
•
Ozone generator (sanitizing system)
•
Aluminum skid
•
Inlet and delivery water pressure gauges
•
Reverse osmosis system
•
Product & drain flow meters
•
TDS meter (handheld)
•
Delivery pump
•
Control panel with single point power connection
LOOSE COMPONENTS
•
200 Gallon Storage Tank (NSF/ANSI Standard 61) with the following pre-installed components:
o
Float switch
o
Ozone tubing
o
1” tank outlet and overflow connection
•
2.75” x 17” Sediment pre-filter
o
Includes PS3038333 filter cartridge (5 micron carbon block)
 This cartridge is sufficient for well water installations and city water with low levels of chlorine
•
9” x 40” Chlorine/chloramine pre-filter (WHRO-700MAX Systems Only)
o
Includes FST-5418-RC filter cartridge (GAC media)
 Recommended for city water applications treated with chlorine
 Required for city water applications treated with chloramine
•
(2) RO elements
•
3/8” product water (blue) tubing
•
Silicone lubricant packets
•
Spare ozone dispersion stones
ITEMS NEEDED TO COMPLETE INSTALLATION
•
3/8” Tubing – for drain line from back of drain flow meter
•
Isolated 15Amp power supply (GFI 120VAC outlet)
•
Drain valve for tank outlet
•
Any additional fittings, pipe, and components per the “Typical Install” drawing