13
Controller Features / Options
RECHARGE CYCLE TIME ADJUSTMENTS
The default durations for fill (0 minutes), solution draw
/ rinse (0 minutes), backwash (25 minutes), and fast
rinse ( 5 minutes), are factory set for maximum filter
performance. Use the following procedure to check
for correct cycle times, or to change if desired.
However, only trained technicians should change the
time settings.
A. ADJUSTABLE FILL TIME
1
. Press and hold for 3 seconds the SELECT button,
until the display shows “000 - -“ (See Figure 19),
then press the SELECT button again to display the
fill time adjust screen (See Figure 20).
FIG. 19
2
. Use the
r
UP or
s
DOWN buttons to adjust fill
time from 0:00 minutes to 99:59 minutes.
3
. When the desired fill time is displayed, press the
SELECT button, and the display will change to
show the next cycle time adjust screen.
B. ADJUSTABLE SOLUTION DRAW /
RINSE TIME
1
. If you completed the previous step, the solution
draw / rinse time adjust screen should show in the
display (See Figure 21). Otherwise, press and
hold for 3 seconds the SELECT button, until the
display shows “000 - -“, then press the SELECT
button twice to display the solution draw / rinse
time adjust screen.
FIG. 21
2
. Use the
r
UP or
s
DOWN buttons to adjust solu-
tion draw / rinse time from 0 to 255 minutes.
3
. When the desired draw time is displayed, press the
SELECT button, and the display will change to
show the 12 / 24 hour clock setting screen.
C. 12 OR 24 HOUR CLOCK
1
. If you completed the previous step, the 12 / 24 hour
clock setting screen should show in the display
(See Figure 22). Otherwise, press and hold for 3
seconds the SELECT button, until the display
shows “000 - -“, then press the SELECT button
three times to display the 12 / 24 hour clock setting
screen.
2
. All time displays are shown in 12 hour (AM/PM)
format at the default setting. If 24 hour time format
is de sired, set to “24 hr” by pressing the
r
UP
button.
3
. Press the SELECT button, and the display will
change to show the next cycle time adjust screen.
D. ADJUSTABLE BACKWASH TIME
1
. If you completed the previous step, the backwash
time adjust screen should show in the display (See
Figure 23). Otherwise, press and hold for 3 sec-
onds the SELECT button, until the display shows
“000 - -“, then press the SELECT button four times
to display the backwash time adjust screen.
2
. Use the
r
UP or
s
DOWN buttons to adjust
backwash time from 0 to 99 minutes.
3
. When the desired backwash time is displayed,
press the SELECT button, and the display will
change to show the next cycle time adjust screen.
continued on next page
FIG. 23
FIG. 20
FIG. 22
