17
4. Programming
Turning the unit off and on enters programming mode. On each instance of
programming mode only a single device may be learnt in. To learn in another
device programming mode must be re-entered by turning the device off then
on again.
4.1. Adding New Remotes
+
TO ADD A NEW REMOTE
1.
Turn the system off, by turning off the power supply.
Wait 10 seconds.
2.
Turn the system on.
3.
Press the remote button several times until the siren
starts beeping.
4.
To test that a remote has been learnt successfully,
immediately attempt to arm the system with the
newly programmed remote. Refer to Section 3 of
this manual for remote operation instructions.
Your
Watchguard Sentinel Home alarm System
can only store a maximum of
FIVE
wireless devices in its memory. If you learn in an 6th remote, the 1st
remote control will be erased. If you lose a remote control, or have one stolen,
or wish to delete a detector simply repeat the procedure above with one of
your remote controls at least 5 times. This will ensure that you have erased all
wireless devices
(except the remote control being used in the procedure)
from
the memory of your
Watchguard Sentinel Home Alarm System.
