Watchguard SMS8RX, Instruction Manual

Page: 5 / 8

5
Wireless PIR, Wireless Reed Switch, Wireless Smoke Sensor)
TO ADD A DETECTOR
1.
On Bank 1, select the Zone (1-8) that you wish to program a detector into. The yellow Program
LED will come on. (If the LED flashes, check that, you don't have more than one dipswitch set to
on).
Note: Learning a new detector into a zone which already had a detector learnt into that zone, will
erase the original detector's code & replace it with the new detector's code. Furthermore, if that
detector code has previously been learnt into another zone, the receiver will determine this as being
an error, and will automatically delete the code duplication by erasing the code from the other zone.
2. Press the Add Button. The red Valid LED will start flashing at 0.5Hz.
3.
Now trigger the sensor. The valid light will stop flashing once the detector has been successfully
programmed.
4. Return all dip switches back to the OFF position. The yellow program light will turn off.
TO DELETE A DETECTOR
1.
On Bank 1, select the Zone (1-8) that you wish to delete a sensor from. The yellow Program LED
will come on. (If the LED flashes, check that, you don't have more than one dipswitch set to on).
2. Press the Delete Button.
3. The detector will now have been erased from the receiver's memory. You can test this by
triggering the detector, and watching that the Valid LED no longer illuminates on your receiver
when the detector transmits, and also by watching that the system no longer is triggered by that
detector.
4. Return all dip switches back to the OFF position. The yellow program light will turn off.
!
1 2 3 4 5 6 7
Bank 1
ON
OFF
1 2 3 4 5 6 7
Bank 1
ON
OFF
E.g. programming a detector into Zone 1
1 2 3 4 5 6 7
Bank 1
ON
OFF
1 2 3 4 5 6 7 8
Bank 1
ON
OFF
E.g.
1 2 3 4 5 6 7
Bank 1
ON
OFF
1 2 3 4 5 6 7
Bank 1
ON
OFF
E.g. deleting a detector from Zone 1
1 2 3 4 5 6 7
Bank 1
ON
OFF
1 2 3 4 5 6 7 8
Bank 1
ON
OFF
Delete
Add Add
…