Watchguard SMS8RX, Instruction Manual

Page: 3 / 8

3
After connecting your SMS8RX to your panel as per the connection diagram on
page 2,
Carry out the default procedure outlined below.
You can default your SMS8RX in case you make a mistake, or are unsure of your receiver setup.
"Defaulting" your receiver will cause all detector & remote codes to be erased .
To default your receiver, follow these steps:
1. Set all dipswitches on Bank 1 to ON.
2. Press & Hold the delete button for 3 seconds
.
3. All LED's on the receiver stop flashing to confirm that the receiver has been defaulted.
4.
Return all dip switches back to the OFF position.
In ‘zone programming’ (option sub-menu 2) ‘enable’ or turn on each wireless zone as
an ‘RF Zone’.
Also you can program to enable or disable the ‘RF remote’ and ‘RF tamper’ in the
menu ‘control timers’ (option sub-menu 4).
PLEASE ENSURE THE PANEL IS PROGRAMMED TO ENABLE EACH RF
FEATURE as described above.
IF YOU ENCOUNTER ANY PROBLEMS WITH YOUR SMS8RX, OR REQUIRE
ADDITIONAL TECHNICAL INFORMATION NOT CONTAINED IN THIS MANUAL,
PLEASE CONTACT YOUR RHINO DEALER.
1 2 3 4 5 6 7
Bank 1
ON
OFF
1 2 3 4 5 6 7 8
Bank 1
ON
OFF
Delete
3 seconds press