Watchguard SMS8RX, Instruction Manual

Page: 4 / 8

4
TO ADD A REMOTE CONTROL
1.
On Bank 1, set dipswitch number 7 and 8 to ON. The yellow Program LED will come on.
2. Press & Hold the button on your remote
3.
Press the Add Button. The red Valid LED will start flashing at 0.5Hz.
4. Now release the button on the remote. The red valid light will turn off.
ACOM
5.
Repeat steps 2 - 4 for any extra remotes that you wish to add. Maximum of 5 can be used.
6. Return dip switches 7 & 8 to the OFF position. The yellow program light will turn off.
NOTE: if the unit is wired to the panel via the BUS connections the system will now arm and
disarm etc.
TO DELETE ALL REMOTE CONTROLS
1.
On Bank 1, set dipswitch Number 7 & 8 to ON. The yellow Program LED will come on. (If the LED
flashes, check that, you don't have more than one dipswitch set to on).
2. Press the Delete Button.
3.
All remote controls will now have been erased from the memory of
the receiver.
4. Return dip switches 7 & 8 to the OFF position. The yellow Program light will turn off.
NOTE WHEN
PROGRAMMING REMOTES
& WIRELESS DETECTORS:
Due to the excellent
performance of the receiver,
you are likely to "swamp" the
receiver with too much RF
signal if you transmit within 5
metres of the receiver. To
prevent this from occurring,
simply remove the antenna
from
your receiver whilst
programming. You will now
have to be within approx 1m of
the
receiver whilst
programming.
IMPORTANT
When programming,
make sure that no
detectors are
transmitting, as they
will interfere with your
programming
procedure.
!
IMPORTANT NOTE:
When installing any wireless device,
make sure that it is at least 5 METRES AWAY from the receiver.
1 2 3 4 5 6 7
Bank 1
ON
OFF
1 2 3 4 5 6 7 8
Bank 1
ON
OFF
1 2 3 4 5 6 7
Bank 1
ON
OFF
1 2 3 4 5 6 7 8
Bank 1
ON
OFF
Delete
Add Add
…