Wassermann Wasi-Steam Classic II, User Manual, Page: 12 / 24

Carefully hook in the unit. Check, whether the unit hangs loosely (i.e. moving back and
forth on the screws). If this is the case tighten the 6x50 screws until the unit hangs
securely.
Finally tighten the securing bracket. First at the wall, then tighten the screw on the unit
itself. (Figure 4)
7 Start-up/ Installation
Before you use the steam cleaner, please put on heat-resistant gloves and wear
safety goggles.
Switch the unit off if it will not be used for an extended period.
Note : Optimal and fast pressurization is carried out only if the adjusting knob is in the
"max." position, since the heater with this is activated via a push button switch, i.e.
immediately at the start of every blasting action.
However in case of the pressure choice options “less than max.”, the heater is activated
via a thermostat, i.e. even in case of a massive decrease in pressure it may take several
minutes until the heater is activated due to residual heat of the container for example.
Therefore this setting “less than max.” is preferable only in case of occasional work.
12
tighten
Phillips head screw
in a final step
fig. 4
Screw 4 x 16