Wasp WWS650, Product Reference Manual

Page: 187 / 316

Product Reference Guide 177
2D SYMBOLOGIES
2D Global Features
• 2D Maximum Decoding Time on page 178 • 2D Normal/Inverse Symbol Control on
page 179
• 2D Structured Append on page 179
The reader supports the following 2D symbologies (bar code types). Symbology-dependent
options for each symbology are included in this chapter. See "1D Code Selection" starting on
page 85 for configuration of 1D bar codes.
2D Symbologies
• Aztec Code on page 180 • Micro PDF417 on page 195
• China Sensible Code on page 183 • QR Code on page 198
• Data Matrix on page 186 • Micro QR Code on page 201
• Maxicode on page 189 • UCC Composite on page 204
• PDF417 on page 192 • Postal Code Selection on page 206
2D Global Features
The following features are common to all, or in some cases, most of the available 2D symbolo-
gies. Default settings are indicated at each feature/option with a green arrow. Also reference
Appendix B, Standard Defaults for a listing of the most widely used set of standard factory set-
tings. That section also provides space to record any custom settings needed or implemented
for your system.
To set most features:
1. Scan the ENTER/EXIT PROGRAMMING bar code at the top of applicable programming
pages.
2. Scan the correct bar code to set the desired programming feature or parameter. You may
need to cover unused bar codes on the page, and possibly the facing page, to ensure that
the reader reads only the bar code you intend to scan.
3. If additional input parameters are needed, go to Appendix D, Keypad , and scan the appro-
priate characters from the keypad.
NOTE
Additional information about many features can be found in the “References”
chapter.
If you make a mistake before the last character, scan the CANCEL bar code to
abort and not save the entry string. You can then start again at the beginning.
Complete the programming sequence by scanning the ENTER/EXIT PROGRAMMING bar code to
exit Programming Mode.