Wasp WDI4200, Quick Reference Manual

Page: 16 / 44

Selecting the Interface Type
6 WDI4200
Selecting the Interface Type
Upon completing the physical connection between the
reader and its host, proceed directly to Interface Selection
below for information and programming for the interface
type supported by the reader and scan the appropriate bar
code to select your system’s correct interface type, accord-
ing to your application.
For interfaces other than those listed in this manual, see
the Wasp WDI4200 Product Reference Guide (PRG), avail-
able online at
www.waspbarcode.com.
Interface Selection
The reader model will support all the following host inter-
faces:
•
RS-232 STD
• RS-232 WN
• USB (Keyboard, COM, OEM)
• USB Composite (Ke COM)
• Keyboard Wedge.
Information and programming options for each interface
type are provided in this section. For defaults and addi-
tional information associated with each interface, proceed
to the corresponding chapter in the Wasp WDI4200 PRG.
Configuring the Interface
Scan the appropriate programming bar code to select the
interface type for your system.
NOTE
Unlike some other programming features and
options, interface selections require that you
scan only one programming bar code label. DO
NOT scan an ENTER/EXIT bar code prior to scan-
ning an interface selection bar code.
Some interfaces require the scanner to start in
the disabled state when powered up. If addi-
tional scanner configuration is desired while in
this state, pull the trigger and hold for 5 seconds.
The scanner will change to a state that allows
programming with bar codes.