2
Wasp Laser Scanner Programming Guide
G
ENERAL
I
NFORMATION
C
HANGING
I
NTERFACES
To change a scanner's interface…
HARDWARE
If necessary, replace the scanner's interface cable to match the new host
terminal's connection requirements. To disconnect the cable from the
scanner, insert a .050” hex driver or bent paper clip into the CABLE RELEASE
hole, and press down to unlock the cable connector. Reference Figure 1.
NOTE
We recommend that you disconnect power
before plugging/unplugging cables to avoid any
possibility of equipment damage.
Interface
Connector
Paper Clip
Cable Release
Figure 1. Disconnecting the Interface Cable
SOFTWARE
1.
Verify that your scanner supports the desired interface
1
. The list
below indicates interfaces available at the time of this writing.
Your scanner comes equipped from the factory with the ability to
connect and communicate with at least two major interface types,
for example, Keyboard Wedge/Wand Emulation and OCIA/RS-232
are two common pairings. Contact Informatics if you don't know
your scanner's interface group, or need to have the scanner
altered to change to another I/F group.
1
Contact Informatics if your desired interface is not listed. Interface group definitions
are subject to change without notice.
Summary of Contents for Bar Code Laser
