BLUE/WHITE 2V (-) LED output: Connect this wire to the blue wire of the supplied LED. Connect the RED wire of
the LED to a fused source of (+)12V.
BLACK (-) chassis ground input: Connect this wire to bare metal, preferably with a factory bolt rather than your
own screw (screws tend to either strip or loosen with time).
RED (+)12V constant power input: Before connecting this wire, remove the supplied fuse. Connect to the battery’s
positive terminal or to the (+)12V feed to the dome light circuit.
NOTE: Always use a fuse within 12 inches of the point you obtain (+)12V. Do not use the 10A fuse
in the harness for this purpose. This fuse protects the module itself.
This system uses a microprocessor-based Learn Routine
™
to learn and store transmitters in memory. Up to four
transmitters are retained in memory, even if the security system is disconnected from the vehicle battery.
To enter the Transmitter/Receiver Learn Routine:
1. Power the system up. If the system is already powered up, it must be powered down
before it will enter the Transmitter/Receiver Learn Routine
™
.
2. Within 5 seconds press
on the first transmitter. The siren will chirp once.
3. Within 5 seconds press
on the first transmitter AGAIN. The siren will chirp twice.
4. Within 5 seconds press
on the first transmitter a THIRD time. The unit will gener-
ate one long chirp.
5. Repeat Steps 2 through 4 for all transmitters that need to be learned. The system can
learn up to four transmitters.
The Transmitter Learn Routine
™
will automatically be exited if 5 seconds elapse without the unit receiving a trans-
mitter code. The system will generate one short chirp followed by a long chirp when the Learn Routine
™
is exited.
TRANSMITTER/RECEIVER LEARN ROUTINE™
WIRE CONNECTION GUIDE
4
© 1999 Directed Electronics, Inc.
N718W 7/99
