10
ASSEMBLY INSTRUCTION
BATTERY
IMPORTANT!
The battery pack (BP8302) is not charged when it is purchased. Before using the hedger
for the first time, place the battery pack on the battery charger and charge. Make sure to read all safety
precautions, and follow the instructions in the Battery Charger section
.
To install the battery
(See Figure 2.)
1. Align the tongue (3) of the battery pack with the cavity in the handle housing.
2. Grasp the rear handle (2) firmly.
3. Push the battery pack into the handle until the latch locks into place.
NOTE:
The battery pack fits snugly into the handle to prevent accidental dislodging. It may require a
strong pull to remove.
To remove the battery
(See Figure 2.)
1. Press Battery pack release button (1) and hold.
2. Grasp the rear handle (2) firmly. Pull the battery pack out of the handle
.
IMPORTANT!
DO NOT remove the blade assembly unless it needs sharpening, straightening, or
replacing. Take it to a qualified person for repair.
WARNING
Follow these instructions in order to avoid injury and to reduce the risk of electric shock or fire
:
•
Arsenic and chromium from chemically treated lumber
.
•
Replace the battery pack or the charger immediately if the battery case or charger cord is damaged.
•
Verify that the switch is in the OFF position before inserting or removing the battery pack.
•
Verify that the battery pack is removed and the switch is in the OFF position before inspecting, adjusting,
or performing maintenance on any part of the hedger.
•
Read, understand and follow the instructions contained in the section entitled Charging Procedure.
Fig. 2
2
