Plugs and Receptacles – 12/24V Locking
Charge plug (red) connects to a 12V-battery charger to allow
simultaneous charging of two (2) 12V batteries when plugged
into receptacle.
Trolling Motor Plug connects to the trolling motor. Jumpered
internally to supply 12V or 24V power to the trolling motor
when plugged into the receptacle.
Corrosion resistant receptacle made of glass reinforced nylon.
Will accept 8 gauge stranded wire, or up to 6 gauge with ring
terminals.
Plug Wiring – Charger/12 Volt trolling motor
Prepare the wires on the battery charger or trolling motor by
stripping 5/8” of insulation off the ends. On the battery charger,
the clamps must be cut off the wires.
Feed the wires through the plug housing. On the 12V charger
plug (red) connect the positive wire toa the terminal marked “12”
and connect the negative wire to the terminal marked “-“.
12 Volt Trolling Motor
On the 12 volt trolling motor plug (red), connect to positive 12
volt wire to the terminal marked “12”, and the negative wire to
the terminal marked “-“.
12 Volt Troll Plug (Red)
Use this plug for 12-volt trolling
motors or chargers. Attach red
wire to port marked “12”. Attach
black wire to port marked “-“.
Make sure all fasteners are tight.
5-2
