INTIG 401 PULSE
DC Pulse Argon Welding Machine
Safety Depends on You
Our arc welding and cutting equipment are designed and built with ample safety consideration.
However, proper installing and operating the machine can increase your safety.
DO NOT INSTALL, OPERATE OR REPAIR THIS EQUIPMENT CASUALLY WITHOUT READING THIS
MANUAL THROUGHOUT.
Special Attention (Very Important):
1. BE SURE TO AVOID THE WELDING MACHINE FALLING DOWN WHEN IT IS
PLACED ON THE GRADIENT GROUND.
2. IT’S FORBIDDEN UNFREEZING THE PIPELINE BY THE WELDING MACHINE.
3. THE SHIELD RANK OF THIS SERIAS OF WELDING MACHINES IS IP21S, SO
WORKING IN RAIN IS NOT SUTABLE.
4. The rated duty cycle of this welding machine is 35%, there is protection
function when the machine is overloading used. When it’s protected and no
power output, must wait and after the temperature back to normal, then use
again.
5. When welding current is lower than 200A, the argon gas flow is 4-8L/min,
when welding current is higher than 200A, the argon gas flow is 8-15L/min
Purchase Date
：
Serial Number
：
Machine Type
：
Purchase Place
：
Cautions
Arc and arc rays can hurt.
All performing welding workers ought to have health qualification from the
authority organization to prevent you and others from arc radiation and
burn, it should be prevented for children to enter into dangerous area as
well.
Be careful reading the following important items and the welder safety
byelaw from the authority organization. Be sure that qualified professionals
perform all installation, maintenances and repair procedures.
- 1 -
