--
Front panel of AIRCUT- 65 I
1)
A (Display) :
This is Ammeter which reads ouput current during cutting
2)
POWER ON
: It will glow when MCB of the machine turned on. It shows the availability of
the input supply.
3)
OVER LOAD
: It will glow when machine is getting heated up for long run of the machine.
When light is on, it stops working automatically. It will go off after some time after sufficient
cooling of the machine.
4)
AIR PRESSURE
: Air pressure indicator – It will glow When the air pressure of the
compressed air is sufficient at input side of the air filter provided on the back panel of the
machine. Spark will not come when it will not glow.
5)
CURRENT CONTROL :
Knob regulating current - Used to adjust the cutting current.
•
+ Ve TERMINAL :
This is positive supply of the machine. Lugged end of the Earthing cable is to be
connected at this terminal & the clamp to the job to be cut.
•
Nozzle :
This is pilot arc point of the machine. Yellow wire of the machine is to be connected here.
•
2PIN CONNECTOR :
This is provided for the cutting switch.
•
-Ve TERMINAL :
This negative supply of the machine
.
Torch air connector is to be connected here.
Back panel of Aircut-65 I
•
MCB
- This is miniature circuit breaker to switch on & switch off the machine. This is also used to
cut off the electricity automatically to protect the machine when it is overloaded or goes anything
wrong.
•
Power input cable
– This is provided to supply the electricity to the machine. There are 4 colored core
wire. R,Y,B colored cable is for 3 phase supply & 4
th
wire yellow & green is for earting of the
machine.
•
Air filter -
It is connected with the air compressor via air pipe. It is used to regulate air pressure and
filter the moisture available in compressed air. Water in the water-logging cup should be drained every
day.
•
Machine earth -
In order to make sure of the personal safety and the normal operation of the
machine please connect this stud to the industrial earth with lead properly, or connect the earth line in
the input cable to the earth properly.
7.
Controls
Summary of Contents for AIRCUT 65 I
Page 21: ...12 Wiring Diagram...
