NOTE:
If equipped with a block heater, route the plug over top of the bumper.
NOTE:
Route the remote extension cable through the bumper opening.
33. Position the front bumper back onto the vehicle and install the outboard retainers.
• On the LH side be sure to place the control module bracket between the frame and the bumper
retainer plate.
• Torque: 76 lb.ft. (Nm 103).
INSTALLATION (Continued)
31. Remove the nuts from the positive and negative battery terminal studs. See Figure below.
32. Connect the winch ground and power cables.
• Install the winch ground cable eyelet (black cable) to the negative battery terminal post and
reinstall the nut.
• Install the winch power cable eyelet (red cable) to the positive battery terminal post and reinstall
the nut.
• Torque: 80 lb.in (9 Nm).
2020-CMY Super Duty
Winch
21
Page 21 of 26
SKLC3J-19E536-AA
© Copyright Ford 2020 FoMoCo
