©2019 Warn Industries, Inc. WARN® and the WARN logo are trademarks of Warn Industries Inc.
5
93953A1
3. Remove brush guard from vehicle.
NOTE: If winch is
installed, remove winch and brush guard as one assembly.
4. Place plow mount weldment (A1) on vehicle and insert four
u-bolts (A6) to hold in place.
5. Temporarily insert the M10 bolts (A3) through vehicle frame
and plow mount tabs to insure mounting holes are lined up
correctly.
6. Once mount is positioned correctly, secure plow mount by
fastening the u-bolts with lock-nuts and tightening to torque
specifications listed on page 3.
7. Remove the M10 bolts.
NOTE: You will use these in the
next step.
8. Install brush guard/winch assembly (
if equipped
) using M10
bolts (A3) and lock nuts (A4) on each side. Tighten to torque
specifications.
U-bolts (A6)
and Locknuts (A5)
M10 Bolt
(A3)
M10 Locknuts
(A5)
Brushguard
Plow Mount
Figure 4
Figure 5
Figure 6
M10 Bolt (A3)
A1
