WARN INDUSTRIES
PAGE 10
84856A0
V. Rubicon & Foreman Specific
Wiring Instructions
1. Contactor Location - Step Three in the
Installation and Specification Guide:
a. The contactor is located in the right rear inner fender,
on the right side of the rear tool box, figures 18, 19
& 20.
b. Remove the wire harness, figure 16, from the
bracket that holds the wire harness in position.
c. Using the drill and 1/4” drill bit, remove the top of the
rivet heads to remove the wire harness bracket.
d. Relocate the wire harness that was removed along
the rear rack tube, figure 18. Use a zip-tie to secure
the wire harness.
It should be noted that the following instructions
are ATV specific only. The following instructions
should be referred to as reference instructions to
assist wiring the winch from the Installation and
Specification Guide supplied in the winch kit.
Notice
Figure 16 Remove Wire Harness from Bracket
Wire Harness
Figure 17 Remove Wire Harness Bracket
Remove Wire Harness
Bracket
Figure 18 Contactor Location - Right Side of Tool Box
Secure Wire Harness
with Zip-Tie
Rear Rack Tube
