WARN INDUSTRIES
PAGE 4
80361A1
©2009 Warn Industries, Inc.
WARN® and the WARN logo are trademarks of Warn Industries Inc.
III. INSTALLATION
1.
Loosen the front bottom skid plate by
removing the front two 6mm bolts, Figure 2.
Keep the 6mm bolts for reinstallation of the
skid plate. Skid plate will not be removed from
vehicle, only will be rotated down. This will
allow room for winch plate installation.
2.
Loosen and remove lower bumper bolts M10.
New bolts (B4) provided in this kit, Figure 3.
3.
Place plow mount in bumper. Align holes on
mounting tabs with the holes in bumper and
frame. Install M10x20 flange bolts (B4)
supplied, but do not tighten at this time.
Figure 4.
4.
Secure plow mount to frame tubes with 5/16
u-bolts (B1) and washers (B2) and nuts (B3)
as shown in Figures 1 & 5.
Tighten all 5/16” fasteners to 12 N-m (9ft.lb.).
Tighten M10 bolts to 27 N-m (20ft-lb.)
Figure 3
Figure 4
Figure 2 Loosen Front Skid Plate
Remove Skid
Install the plow mounting tabs.
1.
The plow mounting tabs supplied in this kit
must be secure to the plow in the position
shown. (Figure 4b).
2.
Loosely install the M10 bolts from the plow kit.
Attach the plow to the plow mount and then
secure the plow mounting tabs. This will insure
the best fit for your vehicle.
Figure 4b
