WARN® INDUSTRIES
PAGE 4
79968A3
and to the hook location on the spring bracket.
Fasten the bracket to the plow base with a M10
carriage bolt through the lower square on the
bracket. Terminate with a 10mm diameter lock
nut, so that spring bracket is tight against plow
base but can still rotate. To set pre load on plow
springs use a 3/8” drive ratchet or breaker bar to
push the spring bracket down. Fasten in place
with an M10 carriage bolt and 10mm diameter
lock nut. See Figure 4.
6. Insert rope guide between flange located towards
the back of the plow base. Use a 10mm x 30mm
shoulder bolt through the top hole of flange to hold
the rope guide in place. Terminate with an 8mm
diameter lock nut. See Figure 5.
Mounting Tabs (92100 Only)
7. Attach the plow mounting tabs to the plow tube
assembly.
NOTE: Mounting tabs are vehicle specific and are not
included in this kit. These parts are included
in vehicle mounting kit.
Use the M10 fasteners included with tube as-
sembly to secure the tabs to the tube assembly.
See Figure 6. Secure tabs to the tube assembly
loosely until plow is secured to mount on vehicle
that is on a flat level surface. This will provide the
best alignment of the plow and mount. Torque
M10 bolts to specification.
Skids
8. Attach the heavy-duty plow skids to the plow
blade. See Figure 7. Slide the skid into the skid
Figure 4 Assemble Plow Springs
Figure 5
Figure 6