WARN® INDUSTRIES
PAGE 3
79968A3
IV. Installation
Latch Lever
1. Assemble the plow lever arm per Figure 1. Run a
10mm dia shoulder bolt through the lever arm side
and out the center hole in the plow base. Use the
small compression spring between the shoulder
screw and the latch. Terminate with a 8mm dia
lock nut. Tighten until the shoulder screw is firmly
against the plow base. Latch lever should rotate
freely.
Stop Blocks
2. Attach both stop blocks, as shown in Figure 1. In-
sert the M10 carriage bolt through each block and
into the plow base as shown in Figure 1. Notice
that hole in stop block is not in the center. This
block produces three blade angle settings and
must be set the same on both sides of base. Ter-
minate with a 10mm dia lock nut.
NOTE: It is recommended to first place the stop block
in the position shown in Figure 1. See the
“ATV Plow Operator’s Guide” for instruction on
blade attach angle settings.
3. Attach the wear bar to the plow blade as shown in
Figure 2. Place 10mm dia carriage bolts through
each of the square holes in the wear bar, and
through their respective holes on the blade. Ter-
minate with a 10mm dia lock nut. Secure nut with
17mm socket and torque wrench.
4. Attach the plow blade to the plow base as shown
in Figure 3. Run a 16mm dia bolt through the
plow blade and base and then through the large
retainer washer and rib bushing. The rib bushing
should rest inside the large hole in the side of the
plow blade rib. Terminate with a 16mm dia lock
nut. Torque the M16 bolt and then check to make
sure the blade rotates freely. It is recommended
to use a light lubricating oil on all plow bushings.
5. Attach the spring to the horizontal rib on the blade
Figure 1 Assemble Plow Lever
Figure 2 Assemble Wear Bar to Blade
Figure 3 Attach Blade to Tube Base