Warmlite WL45037, Manual

Page: 9 / 16

9 www.warmlite.co
USING YOUR APPLIANCE
1. Use the “I/O” switch located on the side
of the stove unit to turn the unit and flame
effect on and off. Flick this switch to the
On position (represented by the symbol
‘I’) to turn the flame effect on, or to the Off
position (represented by the symbol ‘O’)
to turn the flame effect off.
2. Use the switches marked ‘I’ and ‘II’ to
select and set the heating level. Turn the
‘I’ switch to the On position to select the
Low heat setting (900W) or turn the ‘II’
switch to the On position to select the
High heat setting (1800W). Flick either of
these switches back to the Off position to
turn the heating off.
3. Once the desired heating level has been
selected, turn the thermostat dial to the
maximum temperature to activate the
heating function.
4. The fire will now operate continuously until
it reaches an internal temperature of 75
degrees. Once this temperature has been
reached, the automatic cut-off feature
will activate and the unit will turn itself
off, to allow the internal temperature to
decrease. The fireplace will then continue
to carry out this automatically controlled
On-Off cycle until manually turned off or
unplugged from the mains.
PLEASE MAKE NOTE OF ALL THE
FOLLOWING INSTRUCTIONS:
Do:
• Always install the fire in accordance with
this guide. If in doubt obtain expert advice.
• Always make sure the electrical socket is
accessible and located adjacent to, but
not above or behind the fire.
• Always disconnect the fire from the
electrical supply before carrying out
cleaning or maintenance.
• Always ensure the product is assembled
in an area that is free from dust, grease or
liquids.
• Always ensure that the correct tools are
used to assemble/install this product.
• Always make sure the fire is firmly secured
in place when complete.