Warmlite WL45037, Manual

Page: 8 / 16

8 CUSTOMER SUPPORT TEAM: +44 (0) 333 220 6056
HANDLING
Before continuing any further with the
installation of this fire please read the following:
• One person should be sufficient to lift the
fire.
• When lifting always keep your back
straight. Bend your legs and not your
back.
• Avoid twisting at the waist. It is better to
reposition your feet.
• Avoid upper body / top heavy bending.
Always bend from the knees rather
than the waist. Do not lean forward or
sideways whilst handling the fire.
• Always grip with the palm of your hand.
Do not use the tips of fingers for support.
• Always keep the product as close to the
body as possible to prevent unnecessary
and undue strain on the body.
• Use gloves to provide additional grip.
• Always use assistance if required.
UNPACKING THE PRODUCT
The unit is supplied in a single package
carton. Carefully unpack the product using the
following procedure:
• Ensure that the product is in the correct
position with the carton wording legible.
• Remove the straps and sleeve.
• Carefully lift the fireplace out of the box.
• Remove the protective packaging and
bag from the suite.
• Locate the fixing pack and put aside.
• Carefully remove the protective film
covering the fire.
IMPORTANT: This surround is only suitable
for use with electric fires.
Please ensure both the wall and floor are
flat before installation, and that an area of at
least 77cm x 25cm is available for installation.
Always ensure there is enough room to place
the fire suite before attempting to install it.
Please ensure that there is an accessible
electrical socket within the space for
installation. The electrical socket must not be
behind or above the suite.
WARNING! Ensure the supply cord is
correctly located within the notches and will
not be trapped when the surround is fitted to
the wall.
1. Route the supply cord through the notch
at the back of the suite.
2. Route the supply cord through the side
of the suite. There will be a notch located
at each side of the suite. Use the notch
nearest to the electrical socket.
SECURING THE SUITE TO THE WALL
(SEE DIAGRAM ON PAGE 10)
1. Attach a mirror clip to the back of each
edge as shown using the 4 x short
screws. Using a 2mm diameter drill bit, re-
drill the holes to stop the MDF splitting.
2. Place the suite to the wall, and mark the
positions of the remaining holes on both
mirror clips.
3. For solid walls, drill 2 holes, each
approximately 35mm deep. Use a 6mm
diameter drill bit. Note: if fitting the fire
to plaster board with a cavity behind it,
proprietary wall fixings (not supplied) will
be required.
4. Insert the wall plugs, then secure the suite
with 2 x long screws (supplied).