29 March 2021
Due to continued product improvement, Warmington Ind LTD reserves the right to change product specifications without prior notification.
All Dimension are in mm
………….
Copyright ©
15
VERMICULITE (COARSE)
-
to be set by Gasfitter
COALS AND LOGS
-
to be set by Gasfitter
Number of Coals per Row
Total Coals
Number of Rows
Model
Bottom
Top
Bottom
Top
Total
SG/EG SN 1250
16
14
2
2
60
SG/EG SN 1500
19
16
2
2
70
Gloves should be worn when handling Ceramic Fibre Coals & Logs: care needs to be taken when handling coals & logs, due to the carbon on the coals
which can stain the surroundings.
HELPFUL HINT: When Hot use metal Tongs
.
Apply a thin layer of Vermiculite over the Burner , just enough to cover the Burner Tray only as shown above.
1: Bottom Row
: assemble 2 bottom rows of coals onto the vermiculite base.
2: Top Row
: assemble 2 top rows of coals onto the bottom row.
•
Each Coal randomly positioned with the Torn (roughest) Face Outward.
Ensure Coal positioning does not directly block the 3 Flame Pilot.
•
The placement of the Coals & Logs may vary to make an even Flame Pattern.
•
Logs and Twigs may be scattered to achieve best Visual Effect.
•
Fit Burner Grate by sliding R & L Side Metal Pins on Grate, into Holes Located on Burner Side Plates , as shown below.
2: Top row
Slide R & LH Grate
Pins into Holes located
on the Burner Side
plates.
1: Bottom row
Model SG780 Shown: Total number of coals will
General coal orientation for optimum effect.
APPLYING THE VERMICULITE:
(Coarse—must be larger than the burner plates holes so not to block them).
Apply with care a thin layer of Vermiculite over the Burner, just enough to cover the Burner Tray only .
NOTE: If the burner flame is uneven, the Vermiculite may need to be changed or sifted to remove the smaller pieces that can block the burners
holes. The smaller pieces can ,cause uneven burn and the unit to run dirty.
