26
Push Button Ignition Installation
Plate
CROSSFIRE
Brass Burner
Straight
Jet
Drill Here
CROSSFIRE
Brass Burner
Tilted Jet
Drill Here
.125"
Plate
STEP 2:
Place
wires through drilled
hole and pull through
until Spark Igniter
bracket is in place on
plate.
STEP 2 - SIDE VIEW, tilted jet
Spark
Igniter
Spark
Igniter
Plate
Plate
STEP 3:
Screw
Spark Igniter to
plate. Make sure tip
of Spark Igniter sits
no further than .125"
away from the inside
edge of the jet.
NOTE: If Spark Igniter
is too high when
fl ush with plate,
run mechanism up
through bottom of
plate.
.125"
.125"
STEP 1:
To place
Spark Igniter in
proper position, the
installer will need
to drill a hole in the
plate.
Measure where to
drill holes by holding
tip of Spark Igniter
no further than .125"
(or 1/8") away from
inside edge of jet.
Drill hole where base
of Spark Igniter sits.
NOTE
: If the burner being installed uses a titled jet, use the 3.0" Spark Igniter. If the burner uses a straight jet, use the
3.25" Spark Igniter.
Use the 3.0" Spark Igniter
Use the 3.25" Spark Igniter
Push Button Ignition
.125"