Warm Tech 5411074136796, Manual

Page: 93 / 116

The starting first phase is showed from the message
‘FEED’
. In this phase are performed the chimney
verification operations and the pellets will be loaded in the melting pot. The successive phase will be
showed from the inscription “
Lighting”
. In this phase there will be the appearance of the first breeding
grounds. This state remains up to when the smokes temperature doesn’t exceed the planned
threshold.
!! ATTENTION !!
From the appearance of the first breeding grounds, some minutes can spend before the end of the
Lighting phase.
At the Switching on the flame isn’t started immediately, depends from the selected functioning
formality. Two formalities are settable: AUTOMATIC or MANUAL, for further details see the
appropriate section.
When the Lighting phase is finished, some minutes will spend necessary for the flame
stabilization. This phase is showed from the message
‘STABILIZATION”
which finishes after
some minutes going up at the work phase
It is possible to switch off the heater in every functioning phase. The switching off performs
pressing the key ON/OFF for two seconds, as previously described.
!! ATTENTION !!
If the heater is switched off, the flame will continue to be present up to the fuel exhaustion
contained in the melting pot, this phase will manage in automatic way both fans and it will have
the duration up to 5-8 minutes.
The switching off phase is displayed from the message ‘
SWITCHING OFF”
present up to the
end of the operation.
Whether the heater is switched or not, on the display will display the hour, the power, and the
planned set temperature.
Note: If the new stove, when its first time using, it is necessary to put a hand of pellet to the fire
pot before hand.