4
5
BlENDER
One Quart Capacity Specifications
• Ratings
120 VAC- 50/60 Hz- single phase
• Motors
Permanently lubricated series-wound
universal type
• Container 44 oz. Polycarbonate or 32 oz. Stainless Steel
• Cord
6 foot 18 gauge three conductor grounding cord with
strain relief
• cETLus
120 Volt models
gROUNDINg INSTRUCTIONS
• For your protection, Waring
®
Commercial Blenders are equipped
with a 3-conductor cord set.
• 120 volt units are supplied with a molded 3-prong grounding type
plug and should be used in combination with a properly connected
grounding-type outlet, as show in Figure A.
If a grounding type outlet is not available, an adapter, shown in
Figure B, may be obtained to enable a 2-slot wall outlet to be used
with a 3-prong plug.
Referring to Figure C, the adapter must be grounded by attaching its
grounding lug under the screw of the outlet
cover plate.
CAUTION:
Before using an adapter, it must be determined that the
outlet cover plate screw is properly grounded. If in doubt, consult a
licensed electrician.
Never use an adapter unless you are sure it is properly grounded.
NOTE:
Use of an adapter is not permitted in Canada
.
OPERATION
1. Put ingredients into container and cover it. Always add liquid
ingredients first, unless otherwise specified in recipe. Do not fill
above MAX line. Plug the blender cord into outlet.
2. With the toggle switch in OFF position, place container on
blender. Be sure container is fully seated and that drive
coupling is properly engaged.
3. This blender has 2 speed settings: HI and LO. Switch toggle to
desired position. To crush ice, use HI speed setting.
4. This blender is equipped with a PULSE option. Hold toggle in
down position to engage PULSE function. Unit will run on HI
speed until the toggle switch is released.
5. When finished processing, set toggle switch to OFF position.
6. Allow motor to come to a complete stop before removing
container from blender.
7.
Note:
Containers with removable bottoms have right-handed
threads. When reassembling, be sure rubber seal is positioned
between the container and the flange on the blade assembly.
ImPORTANT
HOT BlENDINg INSTRUCTIONS
To minimize the possibility of being scalded when blending hot
materials, the following precautions and procedures must be
observed.
1. Limit the amount of materials processed to 1/2 pint.
2. Completely remove the center portion of the two-piece
container lid before starting motor. (This will allow venting of the
Rubber Seal
