Waring 6001C IB, Instructions Manual

Page: 3 / 8

3
ASSEMBLY-DISASSEMBLY INSTRUCTIONS
IMPORTANT:
Juice extractor should be unplugged from outlet when
disassembling.
ASSEMBLING (SEE FIG. 1):
1. To assemble juicing assembly,
place bowl on base housing and
place spout facing front between
the two raised projections.
2. Place basket inside the bowl
over the hex nut. Be certain
basket sits flat.
3. Place cutter blade inside basket
with teeth up.
4. Tighten spring clutch finger-tight
or snug.
5. Your juicer includes a 20 pack of
filters. Using the filters is optional. If
using the filter, insert the filter inside
the basket and open the filter so that it covers the
inside perimeter of the basket. The filters can be purchased
as a 200 pack accessory with model number CAC66.
Contact your local Waring dealer for more information or visit
www.waringcommercialproducts.com to locate a dealer.
6. Place cover on bowl with feeder chute to right rear and turn it
counterclockwise to secure
beneath spring clips.
7. The juice extractor will not operate until the cover is properly
assembled in place.
DISASSEMBLING (SEE FIG. 1):
1. With juice extractor facing you (spout front) put your hands
on both sides of the cover. Using the sidearms, turn cover
clockwise. This will disengage the cover from the spring clips
and allow you to lift off the cover.
2. Looking into juice extractor, remove spring clutch by unscrewing
counterclockwise.
3. Lift out cutter blade.
4. Lift out strainer basket.
5. Lift off bowl.
Plunger
Feeder Chute
Cover
Spring Clutch
Cutter Blade
Strainer Basket
Bowl
Spout
Spring Clip
Sidearms
Hex Nut
Motor Base
Housing
FIG. 1
Juicing Assembly